And, if you leave a comment, you'll have a chance to win this beauty! So get those comments in people!
One comment per person please. Winner will be selected May 21st at noon (MST) via random.org.
**EDIT** We have a winner!! Random.org chose comment #24--Theresa Crabb claim your prize!
Theresa--please email our customer service department at email@example.com with your address info so we may send out your super sweet and free stacked bow!You will need: **Note** For a complete list of items needed to make the pieces of this stacked bow, click on the highlighted links on the piece name. That will take you to an older post of how to make the piece you are clicking on. 1 Boutique Bow (minus the finishing ribbon and clip) 1 Loopy Surrounder Bow 1 Layered Spike Bow (minus the finishing ribbon and clip) 1 Topper Bow (minus the finishing ribbon) Lined French Clip (or you can leave it unlined, whatever you prefer) 1 Scrap Piece of Coordinating Ribbon Scissors Lighter (not shown) Glue Gun and Sticks (not shown) Directions:
Now glue it to your boutique bow as shown below. Or sideways if you like. It's totally up to you. Careful not to burn yourself!
Make sure you put some pressure on the spot with the glue and give it a minute or so to dry before moving onto the next step. We need this thing to be sturdy!
Next, using a good fair amount of glue in the center (because this piece is pretty bulky), hot glue your layered spikey bow on top of the loopy surrounder bow.
Again, put some pressure on it with your fingers and hold for a minute or so.
You could stop here and finish off. But, since this is a stacked bow, and I need to use those pieces you've learned to make, let's hot glue that topper bow in the center of your layered spike bow.
Looking cute! Now for finishing up!
Take your scrap ribbon piece and tie a knot in the center. Or you can just leave it straight if you like. Glue the lengthwise center of that piece to the vertical center of your bow.
Now take the bar out of the center of your french clip and hot glue it to the back of your bow.
Take the tails on that scrap piece of ribbon and wrap them around the back of your bow.
Hot glue the ends to the underside of your french clip. Trim the ends off and heat seal with your lighter.
*TIP* Use your lighter to burn off any flyaway glue pieces. Just run it lightly and quickly over them--don't linger or you'll burn the ribbon or your hand!
Now you can put the bar back into your french clip and we're done!
Don't you just love it? Your turn! Give it a go. It isn't as hard as it looks. Don't forget, this would look absolutely darling slipped through a crochet headband. Baby headbands are just getting so fun, aren't they?